1994 - 2001 Honda Civic CR-V AC Compressor

New TRS090 Air Conditioning A/C Compressor Complete With 4 Groove Clutch Assembly For Honda Civic, Civic Del Sol, And CR-V.
$135.00
List Price: $284.47
You save $149.47
Part # 30402N
Available
Quantity:

New TRS090 A/C Compressor fits the following vehicles:

  • Honda Civic CX (1994 - 1995) - L4 1.5L GAS
  • Honda Civic CX (1996 - 2000) - L4 1.6L GAS
  • Honda Civic Del Sol S (1994 - 1995) - L4 1.5L GAS
  • Honda Civic Del Sol SI (1994 - 1995) - L4 1.6L GAS
  • Honda Civic Del Sol VTEC (1994 - 1995) - L4 1.6L GAS
  • Honda Civic DX (1994 - 1995) - L4 1.5L GAS
  • Honda Civic DX (1996 - 2000) - L4 1.6L GAS
  • Honda Civic EX (1994 - 2000) - L4 1.6L GAS
  • Honda Civic GX (1998 - 2000) - L4 1.6L CNG
  • Honda Civic HX (1996 - 2000) - L4 1.6L GAS
  • Honda Civic LX (1994 - 1995) - L4 1.5L GAS
  • Honda Civic LX (1996 - 2000) - L4 1.6L GAS
  • Honda Civic SI (1994 - 2000) - L4 1.6L GAS
  • Honda Civic Value Package (1999) - L4 1.6L GAS
  • Honda Civic VX (1994 - 1995) - L4 1.5L GAS
  • Honda CR-V EX (1998 - 2001) - L4 2L GAS
  • Honda CR-V LX (1997 - 2001) - L4 2L GAS
  • Honda CR-V SE (2000 - 2001) - L4 2L GAS
Sanden Aftermarket TRS090 - 4 Groove Clutch 3.95" Diameter, 1.95" Gauge Line - Direct Mount (4 Boss)
 
A/C Compressor reaplacement labor time is 1.4 hours, not including evacuate & recharge.  Add .5 hours for vehicles with Power Steering.
 
Sample vehicle is a 2000 Civic 1.6.  Most vehicles will use the same procedures.
 
A/C Compressor Removal & Installation
 
1. If the compressor is marginally operable, run the
engine at idle speed, and let the air conditioner
work for a few minutes, then shut the engine off.
2. Disconnect the negative cable from the battery.
3. Recover the refrigerant with a recovery/recycling/
charging station
4. Remove the bolts, then disconnect the suction and
discharge lines from the compressor.
NOTE: Plug or cap the lines immediately after disconnecting
them to avoid moisture and dust contamination.
 
5. Remove the condenser.
NOTE: Do not disconnect the discharge hose from
the condenser.
6. Remove the power steering pump belt
7. Loosen the center nut of the idler pulley and the
adjusting bolt, then remove the A/C compressor belt
from the pulleys. Remove the two mounting bolts
from the left front mount, then remove the A/C compressor
belt by passing it through the gap between
the body and the left front mount.
 
8. Remove the four mounting bolts and the compressor.
 
9. If necessary, remove the compressor bracket as follows:
Remove the nut and the washer.
NOTE: When tightening the nut of the left front
mount, make sure the washer is set properly on
the left front engine mount as shown.
Remove the four mounting bolts and the compressor
bracket.
 
10. Install in the reverse order of removal. Make note of
the following items:
If you’re installing a new compressor, drain all
the refrigerant oil from the removed compressor,
and measure its volume. Subtract the volume of
drained oil from 130ml (4 1/3 fl•oz, 4.6 Imp•oz);
the result is the amount of oil you should drain
from the new compressor (through the suction
fitting ). (this compressor comes with a full charge of oil)
Replace the O-rings with new ones at each fitting,
and apply a thin coat of refrigerant oil
before installing them.
NOTE: Be sure to use the right O-rings for HFC-
134a (R-134a) to avoid leakage.
 
Use refrigerant oil (SP-10) for R-134a Sanden and
Hadsys spiral type compressors only.
 
To avoid contamination, do not return the oil to
the container once dispensed, and never mix it
with other refrigerant oils.
 
Immediately after using the oil, replace the cap
on the container, and seal it to avoid moisture
absorption.
 
Do not spill the refrigerant oil on the vehicle; it
may damage the paint; if the refrigerant oil contacts
the paint, wash it off immediately.
Adjust the A/C compressor belt
and the power steering pump belt.
 
Charge the system, and test its
performance.
 
The Accumulator or Filter Drier should always be replaced when the Air Conditioning System is opened.  (see why)  The Orifice Tube, if equipped, should always be replaced and the Expansion Valve, if equipped, should at least be inspected for proper operation if not replaced.  (see why)
ACDelco: 15-20998, 15-21006
CarQuest / NAPA: 254416
Everco: A94416
Frigette: 204-791, 204-1487
Four Seasons: 77560, 78560
Honda: 38800-P06-A02, 38800-P2F-A01, 38810-P06-A04, 38810-P06-A05, 38810-P06-A06, 38810-P2F-A01, 38810-P3F-006, 38810-P3F-016, 38810-P76-016
Omega: 20-03057
Proliance: 2241, 2241N, 2294
Sanden: 3057, 3059, 3062, 3064 4955, 4993
Visteon: 000517